SEWTECHSupport Center 简体中文

Set Up Flat Embroidery on the ST-1501

Applies to ST-1501

Watch on YouTube ↗

Overview

This flat embroidery project uses the table and an aluminum frame to support a larger piece of fabric.

Step-by-step guide

1. Mount the flat table

Watch at 00:20

Fit the support brackets to the tabletop and attach it at the machine's mounting points. Check that the surface is stable before hooping.

Mount the flat table
Mount the flat table

2. Hoop the fabric and stabilizer

Watch at 03:39

Place stabilizer behind the fabric and secure the assembly evenly. Check for wrinkles before mounting the frame.

Hoop the fabric and stabilizer
Hoop the fabric and stabilizer

3. Check the bobbin before the run

Watch at 05:41

Confirm there is enough bottom thread, then select the design, colors and correct aluminum hoop profile. Use the position controls and trace before starting.

Check the bobbin before the run
Check the bobbin before the run

4. Remove the frame after stitching

Watch at 08:20

With the machine stopped, loosen the illustrated fasteners and remove the frame using the demonstrated grip. Release the fabric to check the finished stitch-out.

Remove the frame after stitching
Remove the frame after stitching