Replace a Needle on the ST-1501
Overview
Replace a broken needle on the SEWTECH ST-1501. The guide shows how to loosen the screw just enough, remove the broken needle, face the new needle’s long groove forward, push the shank all the way up and secure the needle.
Step-by-step guide
1. Get the tools and replacement needle ready
Watch at 00:08Bring the ST-1501 to a complete stop before working at the needle head. Have a small flat-blade screwdriver, needle-nose pliers and a replacement needle for the ST-1501 ready. The screwdriver is for the retaining screw. The pliers are for removing the broken needle and holding the replacement.


2. Slightly loosen the needle-retaining screw
Watch at 00:16From the front of the head, follow the damaged needle up to its holder. Fit the flat blade into the small slotted screw at that needle position. Turn gently just enough to release the needle, leaving the screw in the holder.


3. Remove the broken needle with pliers
Watch at 00:30Grip the exposed part of the broken needle just below the loosened holder. Withdraw it carefully downward while keeping hold of it with the pliers. Once the remaining needle is clear of the holder, use that same opening for the replacement.


4. Face the long groove toward the front
Watch at 00:44Hold the new needle with the point down. Find the long groove running along the blade toward the eye. When you are facing the machine, that groove should face you. Keep this orientation when you lift the needle into place.


5. Guide the shank into the holder from below
Watch at 00:55Bring the new needle to the same position with the shank up and the point down. Line up the shank with the opening on the underside of the holder and guide it upward by hand, keeping the groove toward the front.


6. Push the needle fully up to the stop
Watch at 01:02Hold the needle steady with the needle-nose pliers as shown. Push it straight up until it stops against the top inside the holder. Keep the needle supported there while you prepare to check its position.


7. Recheck the seating and groove
Watch at 01:15Before tightening, check that the needle is still fully up against the stop and that the long groove still faces forward. If the needle has slipped down or turned, reseat it with the groove facing you before tightening the screw.


8. Tighten the same retaining screw
Watch at 01:28Keep the needle steady with the pliers so it stays seated and facing forward. Return the flat-blade screwdriver to the same screw and tighten it securely. Once the screw is tight, withdraw the screwdriver and pliers.


9. Confirm the needle stays in place
Watch at 01:36With the tools clear, confirm that the replacement remains straight and seated in the holder, with the long groove facing the front. The video ends with the needle head stationary after this visual check.

