SEWTECHSupport Center 简体中文

Troubleshoot Thread Breaks on the ST-1201 and SC-1501

Applies to ST-1201 / SC-1501 Demonstrated on ST-1201

Watch on YouTube ↗

Overview

This SEWTECH TV walkthrough checks the bobbin, needle and upper thread when the thread repeatedly breaks during embroidery.

Step-by-step guide

1. Check the bobbin and perform a drop test

Watch at 00:27

Replace an empty bobbin. If the suspended case hardly moves during the test, loosen the larger screw slightly and retest for a smooth 3–5 cm drop.

Check the bobbin and perform a drop test
Check the bobbin and perform a drop test

2. Inspect the needle orientation and condition

Watch at 01:28

With the machine stopped, seat the needle all the way up with its long groove forward and scarf back. Replace a worn needle and secure the clamp screw.

Inspect the needle orientation and condition
Inspect the needle orientation and condition

3. Check the threading from spool to needle

Watch at 02:24

Look for thread trapped at the spool cap, between guides or at the tension discs. Re-seat it along the demonstrated route and pull gently again to check the movement.

Check the threading from spool to needle
Check the threading from spool to needle