Change Embroidery Design Direction on the ST-1501
Overview
Use the Direction control on page 2 to change a flat design, then check its orientation and frame boundary before stitching. This ST-1501 lesson also shows how to unlock Direction and confirm the automatic cap orientation.
Step-by-step guide
1. Select the design and open page 2
Watch at 00:10On the ST-1501, select the design you intend to stitch from the thumbnail list while the controller is out of embroidery mode. The flat-work example uses KML. Tap the second tab from the left on the strip below the design area. The tab turns gold and the lower panel shows Direction and Angle.



2. Cycle through Direction presets
Watch at 00:15Tap the blue value button beside Direction. Each tap cycles to another preset and changes the upper preview. The sequence includes reflected views, so use the orientation of the lettering to check your choice. Leave the separate Angle field as it is for this procedure. It stays at 0 in the demo.



3. Check the rotated preview
Watch at 00:29Stop when the design faces the intended way for the fabric in the hoop. In the video’s 90° example, KML is vertical, with K at the bottom and L at the top. Look at the lettering itself to confirm the direction before checking the frame boundary.


4. Open page 4 and check the frame boundary
Watch at 00:45Open the fourth tab on the same strip. The frame view shows the selected hoop as a green outline. In the clip, the presenter taps the top-center button in the compact tool grid to the left of the blue arrow pad. Before stitching, use the trace function and confirm the design stays within the usable area of the mounted hoop. The clip shows the fit on the display.



5. Enter embroidery mode and check the stitch preview
Watch at 00:52Open page 5 with the next tab to the right. Tap the red mode control at the far right of the tab strip and tap the check mark in Confirm EMB? Wait for the preview to load. The gray stitch preview should still match the chosen direction. In the example, KML remains vertical and the mode control turns blue.



6. Recognize a direction lock
Watch at 01:02If Direction fails to change on page 2 and the controller reports that the pattern is in use, close the warning with the exit icon. Check the far-right mode control on the strip. The blue state shown here means embroidery mode is still active and Direction is locked.


7. Cancel embroidery mode and retry Direction
Watch at 01:19Tap the blue mode control and choose the check mark in Cancel EMB? Wait for the control to return to red. Then tap Direction again on page 2. A change in the preview confirms that the direction is editable again.



8. For cap embroidery, leave the design upright
Watch at 01:29Select the cap design from the list and open page 2. The video shows the DAD example upright on that screen. Leave Direction as it is and continue to the cap-frame selection on page 4.


9. Select and confirm the cap frame on page 4
Watch at 01:37Open the fourth tab and tap the Cap Frame tile. It is in the middle of the third row in this clip and is labeled Cap Frame 270X70. Tap the check mark at the bottom of the frame list. When the controller warns that the frame may move, check clearance around the mounted frame and confirm with the dialog’s check mark when clear.




10. Verify the cap’s automatic 180° rotation
Watch at 01:43Check that the design fits inside the green cap-frame outline. Then open page 5, tap the red embroidery-mode control and confirm the prompt with its check mark. After the preview loads, compare it with the upright page-2 design. On this ST-1501 the preview turns DAD by 180° automatically for cap embroidery. Confirm the resulting placement before starting.


