Install and Adjust HoopSteady
Overview
Set up HoopSteady with the machine stopped. Have a caliper, a metric ruler and a hex key ready. The video shows how to size both pairs of clamping blocks to the cylinder arm, check the fit, and extend the support beneath a larger hoop. Use your machine’s measured width. The 50 mm shown here is an example.
Step-by-step guide
1. Check the initial fit
Watch at 00:15Slip the unadjusted support onto the cylinder arm and gently wiggle the front end. The demonstration shows some play before adjustment. This is the point to size the clamping blocks to your machine.


2. Remove the support and measure the arm
Watch at 00:28Take HoopSteady off the machine. Place the caliper’s outside jaws against the two sides of the cylinder arm at the mounting area. Record the width. The reading is about 50 mm (5 cm) in the video.


3. Align the ruler with the centerline
Watch at 00:59Turn HoopSteady underside up and identify the centerline between the two rails. Lay the ruler across the blocks and align its 10 cm mark with the centerline as shown. Halve the width you measured. A 50 mm opening calls for 25 mm on each side of center, at the 7.5 cm and 12.5 cm marks in this example.


4. Set the first pair of clamping blocks
Watch at 01:22Insert the hex key into the screw on the outer face of each white end block. Follow the Loose and Tighten arrows printed around the screw. Watch the block extend as you turn toward Tighten. Alternate sides and check that both inner faces are the same distance from the ruler’s center mark. Their total opening should match the measured arm width.



5. Expose the extension-slide screws
Watch at 01:43Keep the support underside up and pull the extension slide out until its two side access holes are exposed. Place the ruler across the second pair of blocks and align it to the same center reference.


6. Measure between the black padded faces
Watch at 01:59Reach the screws through the side holes with the hex key and adjust both sides evenly. The blocks extend as the screws turn toward Tighten. Read the ruler at the inward-facing edges of the black pads. Check that each edge is the same distance from center and that their gap matches your cylinder arm.



7. Pull the white handle to open the lower plate
Watch at 02:22Find the white release handle underneath the front of the support. Pull and hold it so the spring-loaded lower plate opens away from the main support. Keep it open as you bring the unit to the cylinder arm.


8. Slide the support fully on and release
Watch at 02:33Guide the open support straight onto the cylinder arm and slide it all the way in. Release the white handle so the lower plate springs back against the arm. Gently wiggle the front to check how firmly it sits.



9. Fine-tune both sides if the support is loose
Watch at 02:49If there is play after mounting, tighten the matching left and right screws by the same number of turns to keep the support centered. The video illustrates two turns per side first, then one more turn per side if needed. It shows the white end-block screws and the extension-slide side screws. Recheck the fit between adjustments.



10. Confirm a secure fit and smooth release
Watch at 03:08Gently wiggle the mounted support again. It should sit securely on the cylinder arm, and it should slide on and off smoothly when you hold the release handle open.


11. Extend the slide to support a larger hoop
Watch at 03:17Pull the front section out to reach farther under a larger hoop. Fit the hoop to the machine arms. Watch the hoop travel over the extended support in the demonstration and check that the support sits beneath the hoop and fabric.



12. Remove HoopSteady
Watch at 03:33With the hoop off as shown, support the front of HoopSteady with one hand. Pull and hold the white handle with the other to lower the bottom plate. Slide the whole unit straight off the cylinder arm.


