Reset a Needle Stuck Down on the ST-1501 and SC-1501
Overview
Use this procedure when the machine has stopped with a needle down and the controller shows a slashed 100° icon. Before using the powered reset, keep your hands clear of the needle, presser foot, and hoop. Leave the hoop in place while the needle is down.
Step-by-step guide
1. Check where the needle stopped
Watch at 00:07Look at the active needle under the head. In the clip, it stays down close to the needle plate after the machine stops. If yours does the same, check the controller and leave the hoop in place while the needle is down.

2. Look for the slash on the 100° indicator
Watch at 00:15Check the right side of the blue status bar at the top of the touchscreen. A slash through the circular 100° symbol means the main shaft is away from its 100° reference position.

3. Find the 100° reset button
Watch at 00:28On the touchscreen shown, the reset button is at the far left of the lower blue toolbar, immediately to the left of the scissors icon. Use this lower button to reset the shaft.

4. Tap 100° and wait for the shaft to reset
Watch at 00:34Tap the lower 100° button once. Keep clear of the head while the controller displays “The machine is in action, please wait…” and a progress bar. Wait for the movement to finish.


5. Confirm the needle is up and the slash has cleared
Watch at 00:38Watch the needle rise clear of the needle plate. Then check the top status bar again. The circular 100° symbol should be visible without a slash. If either check fails, leave embroidery stopped.



6. Open the manual needle selector
Watch at 00:54After the needle is up and the 100° status is clear, tap the three-needle icon in the bottom toolbar, just to the right of the scissors. The controller opens a panel with the 15 needle numbers.


7. Select a different needle to complete the color change
Watch at 00:56Tap the needle number for the color you need and wait for the head to finish shifting. Check that the new number is highlighted. The video changes from needle 7 to needle 5 as an example.


8. Return to the controller’s main view
Watch at 00:59Use the return icon at the lower right of the needle selector, just above the blue toolbar. Check that the needle grid closes and the main controls are visible again.


9. Resume embroidery and check the first stitches
Watch at 01:01Once the needle has lifted, the 100° slash has cleared, and the selected needle is in position, resume embroidery. Watch the first stitches and check that the needle cycles normally. The video cuts to stitching a letter F in a round hoop.

