Flat Embroidery Demo with the 8 × 14 in Magnetic Sash Frame
Overview
This 46-second SEWTECH TV demo shows flat embroidery on the ST-1201. It uses the 8 × 14 in magnetic sash frame, with a 200 × 360 mm embroidery field. Have the frame base and magnetic bars, a flat fabric panel and backing ready. The clip starts at the flat table and cuts from the Start control to stitching already in progress.
Video highlights
1. Fit the sash frame to the carriage
Watch at 00:03Set the rectangular metal base on the flat table and slide it back under the needle head. Line up the rear mounting tabs with the carriage rail, seat them against the rail, and turn the black hand knobs on both sides to secure the frame. The base sits flat on the table when seated.




2. Lay the backing and fabric flat
Watch at 00:07Spread the white backing sheet over the opening first. Lay the white face fabric over it and smooth the stitch area with both hands. Leave enough material to reach past the frame edges so the magnetic bars can grip the layers.


3. Clip the magnetic bars onto the long edges
Watch at 00:10Set the first white magnetic bar onto the rear long edge behind the needle head. Hold the front bar at both ends, line it up with the front metal edge and lower it onto the fabric. Seat the remaining magnetic pieces along the long edges, keeping the middle of the panel smooth as they snap down.



4. Secure the two short edges
Watch at 00:17Place a side bar on the left short edge, then lower the matching bar onto the right. Check that the bars sit along all four edges and the area inside the frame lies flat. The red positioning light is visible on the white fabric under the head.


5. Start from the embroidery screen
Watch at 00:18The floral design is already visible on the ST-1201 touchscreen. Press the blue-ringed physical Start button below the screen, to the left of the pink-ringed button. The next shot shows the design already stitching inside the frame.


6. Watch the frame move as the design fills in
Watch at 00:21Watch the carriage move the clamped fabric beneath the active needle. The close-ups show separate colored stitch areas filling in and green stems and leaves appearing below the flowers. The fabric stays flat across the opening as it moves with the sash frame.



7. Check the on-screen progress
Watch at 00:36The touchscreen close-up shows the floral preview in color as stitching progresses. Compare it with the next shot of the framed fabric, where the same row of flowers and part of the green detail are visible.


8. Inspect the finished floral design
Watch at 00:44The final close-up shows six flower heads in purple, pink, blue and yellow above green stems and leaves. Look across the whole row to see how the finished motif sits flat on the white panel while it is still in the frame.
