SEWTECHSupport Center 简体中文

Change Embroidery Design Direction on the ST-1501

Applies to ST-1501

Watch on YouTube ↗

Overview

Change direction on the controller and check the preview before stitching. Cap selection has its own orientation behavior.

Step-by-step guide

1. Use the direction control on page two

Watch at 00:10

Open the direction setting and tap until the preview faces the intended way. Exit embroidery mode first if the control is locked.

Use the direction control on page two
Use the direction control on page two

2. Check the preview and trace the hoop

Watch at 00:30

Verify the direction and placement in the preview. Trace the design to confirm the embroidery fits inside the hoop.

Check the preview and trace the hoop
Check the preview and trace the hoop

3. Check the cap hoop preview

Watch at 01:24

For cap embroidery, select the cap hoop. The demonstrated controller applies the cap orientation automatically. Verify the result on the preview.

Check the cap hoop preview
Check the cap hoop preview