SEWTECHSupport Center 简体中文

Fix Wobbling on 8-in-1 and 6-in-1 Magnetic Hoops

Tool 8-in-1 and 6-in-1 magnetic hoops

Watch on YouTube ↗

Overview

This video compares the vertical gap beneath the hoop before and after the washer adjustment at the mounting brackets.

Step-by-step guide

1. Inspect the vertical gap under the frame

Watch at 00:10

Look at the space between the mounted frame and the needle plate. The video shows how an excessive gap lets the frame bounce under the moving presser foot.

Inspect the vertical gap under the frame
Inspect the vertical gap under the frame

2. Align flat washers at the mounting points

Watch at 00:40

With the frame off the machine, place the flat washers at the bracket screw holes shown. Keep the holes aligned and repeat on the opposite side.

Align flat washers at the mounting points
Align flat washers at the mounting points

3. Tighten, reinstall and check the clearance

Watch at 01:37

Secure both brackets and reinstall the frame. Check that it sits level and inspect the gap and free frame movement before embroidering.

Tighten, reinstall and check the clearance
Tighten, reinstall and check the clearance