SEWTECHSupport Center 简体中文

Set Up and Use the SEWTECH Bobbin Winder

Tool SEWTECH bobbin winder

Watch on YouTube ↗

Overview

Fit the thread guide, route the thread through the tension disc and wind an empty bobbin.

Step-by-step guide

1. Fit and tighten the thread guide stand

Watch at 00:28

Loosen the locking nut, screw in the stand and orient it as shown before tightening the nut with the wrench.

Fit and tighten the thread guide stand
Fit and tighten the thread guide stand

2. Route the thread and prepare the bobbin

Watch at 00:59

Pass the thread through the upper guide and tension disc. Place an empty bobbin on the spindle and wrap the end counterclockwise as demonstrated.

Route the thread and prepare the bobbin
Route the thread and prepare the bobbin

3. Wind and remove the full bobbin

Watch at 01:54

Start winding with the red button and check the line accumulates evenly. After the winder stops at full, remove the bobbin and cut the thread.

Wind and remove the full bobbin
Wind and remove the full bobbin