Move Forward or Back by Stitches on the ST-1201 and SC-1501
Overview
If the thread breaks and the machine travels a few stitches before stopping, rethread the active needle and move the stitch position back to the end of the last intact stitches. This demonstration on the ST-1201 shows fixed-count and continuous movement, single-stitch adjustments, and how to resume. A letter M, 10 stitches back, and 5 stitches forward are examples from the video.
Step-by-step guide
1. Stop and rethread the active needle
Watch at 00:11Wait until the machine stops. Leave the material hooped and keep the current design open. Find where the thread stopped forming stitches and rethread the active needle before moving the hoop.


2. Open the stitch-movement controls
Watch at 00:34On the main embroidery screen, tap the third tile in the top row of the lower-left controls. The lower part of the screen changes from the hoop-direction pad to the stitch-movement panel. Find the fixed-count field in the bottom row of this panel.


3. Set a fixed stitch count
Watch at 00:40Tap the number between the minus and plus direction buttons in the bottom row. Enter the number of stitches on the keypad, then tap the blue check mark to confirm. Check that the keypad closes and the new number appears between those buttons. The example changes the count from 100 to 10.



4. Move back by the set count
Watch at 00:58With the machine stopped, lower the presser foot slightly so you can compare the active needle position with the stitches on the fabric. Keep your fingers clear before moving the hoop. Tap the minus button to the left of the set count to move back by that number. Let the hoop stop and check the position before tapping again.



5. Move forward if you went back too far
Watch at 01:14Tap the same count field again and enter a smaller number, then confirm with the check mark. Tap the plus button to the right of the number to advance by that count. In the video the correction is 5 stitches. Check the actual needle position again before moving farther.


6. Fine-tune one stitch at a time
Watch at 01:27Use the left-hand pair in the middle row of the stitch-movement panel when you are close to the restart point. The minus button moves back one stitch per tap and the adjacent plus button moves forward one stitch per tap. Check the fabric between taps so you can stop at the end of the intact stitching.


7. Start and stop continuous reverse
Watch at 01:34For a longer move, use the left-hand pair in the top row of the stitch-movement panel. After rethreading, lower the presser foot slightly while stationary, then keep your hands clear. Tap the left button once to start continuous reverse. Follow the changing stitch-path preview and the position on the fabric. Tap that same button again to stop at the target.



8. Correct an overshoot with continuous forward
Watch at 01:58If you have moved too far back, stop reverse first. Tap the right button of the same upper-left pair to start continuous forward. Watch the needle approach the last intact stitches, then tap that button again to stop. Use the single-stitch buttons for any final adjustment.


9. Resume at the verified stitch position
Watch at 02:10Confirm that the active needle is lined up with the end of the intact stitches on the fabric and that movement has stopped. Tap the return icon in the lower-right corner of the stitch panel to bring back the main embroidery controls. With your hands clear, press the physical Start button below the left side of the screen. Watch the first new stitches join the existing stitching without a gap.



10. Zoom and pan the stitch preview
Watch at 02:20Tap the plus zoom control near the lower-right edge of the design preview to see individual stitches more clearly. Drag inside the preview to bring the area you want into view. Press and hold the same zoom control until it changes from plus to minus, then tap minus to zoom back out to the full design. Check the restart point on the fabric before pressing Start.



