SEWTECHSupport Center 简体中文

Embroider a Cap on the ST-1501

Applies to ST-1501

Watch on YouTube ↗

Overview

Prepare the cap station, carrier and backing, then fit the cap driver and position the design on the ST-1501.

Step-by-step guide

1. Set up the station and cap hoop

Watch at 01:10

Secure the station and listen for the cap hoop clips to engage. Prepare stabilizer for the front of the cap.

Set up the station and cap hoop
Set up the station and cap hoop

2. Clamp the cap over the backing

Watch at 04:00

Arrange the cap over its backing, line up the cap edge with the strap and clamp it as shown. Check the front panel is smooth.

Clamp the cap over the backing
Clamp the cap over the backing

3. Fit the cap driver

Watch at 07:48

Stop and power off the machine for driver installation. Follow the demonstrated alignment and tighten the mounts when seated.

Fit the cap driver
Fit the cap driver

4. Choose the cap profile and mount the hooped cap

Watch at 10:11

Select the cap frame on the controller, check the bobbin and seat the cap hoop on the driver.

Choose the cap profile and mount the hooped cap
Choose the cap profile and mount the hooped cap

5. Trace and then stitch

Watch at 12:43

Center the design and run a trace around the cap. Confirm the clearance, then enable embroidery and start the design.

Trace and then stitch
Trace and then stitch