Resume Stitching After a Thread Break
Overview
If the hoop has shifted after a thread break, use END on page 5 to return to the saved stop point while the current job is still active. Inspect the stitching under the needle, back up if you find a gap, then restart and watch the first stitches.
Step-by-step guide
1. Prepare to resume after the stop
Watch at 00:19With the machine stopped, rethread the affected needle and check that the fabric and hoop are still secured. Keep the current design in embroidery mode and leave the X-axis beam in place. The original stop point can be hard to locate by eye if the hoop has shifted.


2. Open page 5 and tap END
Watch at 00:41Select the fifth tab in the strip directly below the design preview. On that page, tap END in the upper-left corner of the square tool grid, immediately left of Home.


3. Confirm the return and watch the hoop
Watch at 00:45When the controller asks “Go To Stop Point?”, tap the check mark. Keep your hands clear while the hoop moves. The prompt closes and the hoop brings the stitched area back beneath the needle. Wait for movement to stop before checking the stitch line.


4. Check the stitches under the needle
Watch at 00:52Before pressing Start, look closely at the last section of stitching beneath the active needle. Check for a gap between the last complete stitches and the current needle position. If the stitching is continuous, go to the restart step. If you find a gap, back up to just before it.

5. Open the stitch-back controls
Watch at 01:01On page 5, tap the needle icon with left and right arrows, two buttons to the right of END. The lower part of the screen changes from the normal tool grid and direction pad to the stitch controls.


6. Set the number of stitches to back up
Watch at 01:06Tap the number between minus and plus on the bottom row to open the numeric keypad. Enter the number of stitches to back up and confirm it. The instructor suggests about 10–15 stitches as a starting point and sets 10 in the demo. Use the gap on your fabric to decide how far back to go.


7. Back up to just before the gap
Watch at 01:09Tap the bottom-row minus button immediately to the left of the count to back up by that number of stitches. Watch the hoop reposition and check that the needle is now just before the gap so the run can cover the missing stitches.


8. Restart and watch the first stitches
Watch at 01:12Return to the normal controller view, clear your hands from the hoop and needles, and press the physical Start button with the blue ring on the left below the screen. Watch the needle resume at the intended spot and check that the new stitches follow the existing design through the gap.


9. Keep embroidery mode active
Watch at 01:20If the on-screen embroidery-mode button at the far right of the tab strip is switched from blue to red, the controller clears the saved stop point. In the demo, the KML preview also disappears. Keep the button blue while using END. If you already canceled the job, leave the machine stopped and follow the recovery procedure for your controller before restarting.


10. Leave the X-axis beam in place
Watch at 01:40After the machine stops, leave the horizontal X-axis beam behind the needle head where it is. Moving the beam by hand invalidates the saved position. If it has already been moved, stop and re-establish the design alignment using the recovery procedure for your controller before resuming.

