SEWTECHSupport Center 简体中文

Resume Stitching After a Thread Break

Applies to ST-1501 / SC-1501 Demonstrated on ST-1501

Watch on YouTube ↗

Overview

If the hoop shifted after the machine stopped, use the saved stop point to return to the design. Check for any missed stitches before pressing Start.

Step-by-step guide

1. Return the hoop to the saved stop point

Watch at 00:40

Go to page five of the controller and tap END. Wait for the frame to return to the position where embroidery stopped.

Select the END button on page five of the controller.
Select the END button on page five of the controller.

2. Back up to cover missed stitches

Watch at 00:51

Check where stitching stopped. If there is a gap, use the stitch-back control to move about 10–15 stitches back to just before it, then press Start to resume.

Inspect the design at the stopping point before restarting.
Inspect the design at the stopping point before restarting.
The stitch-back controls let you return to a point before the gap.
The stitch-back controls let you return to a point before the gap.

3. Check whether the stop point is still stored

Watch at 01:20

The video shows two actions that clear the stored position: canceling embroidery mode and manually moving the X-axis beam. END can restore the position while the stop point is still saved.

The video illustrates manual X-axis beam movement, which clears the saved point.
The video illustrates manual X-axis beam movement, which clears the saved point.