Change the Upper Thread on the ST-1201 and SC-1501
Overview
Use the old upper thread as a leader when changing colors or replacing a cone. With the machine stopped, have the new cone and a pair of thread snips ready. Start with the old thread still running through its guides. The demonstration is on the ST-1201, with the same knot method for the SC-1501.
Step-by-step guide
1. Cut the old thread at the cone
Watch at 00:19With the machine stopped, identify the cone and needle path you want to change. Cut the old thread above that cone, below the overhead guide plate. Hold onto the end that still runs up into the guide so it is available for tying.


2. Fit the replacement cone
Watch at 00:27Lift the old cone off its stand and seat the new cone in the same spot. Bring its free end up to meet the old thread below the guide plate. The video changes from green to red.


3. Tie a small joining knot
Watch at 00:38At the spool stand, tie the new thread to the machine-side end of the old thread with a small, snug knot. The close-up shows the two colors meeting below the guide plate. Trim the loose ends next to the knot, leaving the joined line intact.



4. Slip the old thread out of the needle eye
Watch at 00:57At the front of the head, find the needle fed by the old thread. Slip its thread tail back out of the needle eye and keep hold of the free end. The narrator calls out this step to protect the needle when the knot is pulled through the rest of the path.


5. Draw the knot through the guide tube
Watch at 01:05Pull slowly by hand on the old thread at the needle end. The knot should rise from the cone stand into the overhead guide plate and follow the same clear tube to the front of the head. Follow the yellow arrow in the video to see where the join is moving.



6. Follow the existing path down the head
Watch at 01:20Keep pulling slowly from the same free end at the needle side. Watch the new color follow the old route past the small thread-break detection wheel, around the corresponding tension wheel and through the lower guides. In the black take-up area, the arrow shows the thread going up to its take-up lever and back down toward the needles. This is one thread path.





7. Pull the knot clear and cut it off
Watch at 01:45Pull until the join reaches the needle area and enough of the new color has emerged to thread by hand. Cut on the new-thread side of the join to remove the knot and the remaining old thread together. Keep a workable tail of the new thread below the head.


8. Thread the needle from front to back
Watch at 01:53Hold the clean end of the new thread and bring it to the front of the needle eye. Feed it through by hand toward the rear of the machine. Catch the end as it emerges and draw a short working tail through the eye.


9. Guide the tail under the presser foot and trim
Watch at 02:06Bring the tail beneath the presser foot at that needle, then lift it to the small metal thread clip above the needle row as shown. Hold the tail in the clip and trim the excess. The final close-up shows the new red thread through the same needle with the tail secured. Check those two points before returning to stitching.



