Align and Focus the ST-1501 Positioning Laser
Overview
Use this procedure with the SEWTECH ST-1501 stopped and the needle plate exposed. Check the red dot at the needle hole first, then load the design and mount your hooped fabric for the trace. If the dot is missing, go straight to the controller settings. If it is visible but stretched or blurry, start with the focus adjustment.
Step-by-step guide
1. Find the dot and the needle hole
Watch at 00:10Look at the metal needle plate directly below the needle head. Use the small round needle hole near the front edge as the reference. The reflected red dot should sit in the center of that hole. If it falls on the metal beside the hole, adjust the laser unit.


2. Move the laser unit by hand
Watch at 00:24Find the black laser unit and its hinged bracket under the thread spool shelf. Gently move the whole unit by hand in small increments while watching the dot on the plate. Stop moving it when the dot sits in the center of the needle hole.



3. Release the unit and recheck
Watch at 00:47Let go of the bracket and check the plate again. The dot should stay centered when your hand is off the assembly. If it shifts when released, make another small adjustment and recheck before running the trace.


4. Trace the design on hooped fabric
Watch at 00:59With the design loaded and the fabric held flat in its mounted hoop, open the frame controls. Tap the dotted-rectangle Trace button in the left control block, directly under the hoop selector and just left of the dashed oval. Clear the frame path and tap the check mark in the move-frame prompt. As the hoop moves, watch the laser dot mark the design boundary on the fabric. Check that the path is within the hoop and that the design is centered where you intend to stitch. GH30 is the hoop selection in this example.




5. Focus a stretched or blurry dot
Watch at 01:23If the red light looks broad or stretched, find the same black unit under the spool shelf. Gently turn only the lens tip counterclockwise a little at a time, as shown. Watch the spot shrink to a small, sharp dot and stop there. Avoid turning the lens tip to the end of its travel. Recheck centering at the needle hole after focusing.




6. Open More Set if the dot is missing
Watch at 01:51If there is no red dot on the exposed plate, check whether the positioning laser is enabled. Tap the hand icon at the far right of the blue bottom bar to open the manual page. Tap More Set in the center of the icon grid.



7. Confirm the settings code if prompted
Watch at 02:05If the Number Pad opens, use the settings code for your controller and tap the check mark. The video shows 823456 on the demonstrated ST-1501. Successful entry opens the parameter list.


8. Open Mac. Config. and go to page 2/4
Watch at 02:13Tap the list icon at the far left of the light-colored row above the blue bottom bar. Select Mac. Config. in the category list, immediately below Trim. On Mac. Config. page 1/4, tap the right arrow beside the page counter to reach page 2/4.



9. Enable item 5, Start needle light?
Watch at 02:23On page 2/4, find row 5, code M100. The touchscreen labels it Start needle light? and the narration calls it Start Needle LED. If the current value is no, tap the green ON button on that same row. Confirm that the value changes to yes.



10. Confirm that the red dot returns
Watch at 02:33Return your attention to the exposed needle plate. The video shows the dot come on after the setting is enabled. Once it is visible, use the needle hole to verify centering and run the trace on your fabric before you stitch.

