Fix a False Thread Break Alarm on the ST-1201 and SC-1501
Overview
If an intact upper thread triggers a Broken Line alert, inspect the threading path first, then check the bobbin and how its thread feeds. After correcting the problem, back up a few stitches and watch the design resume. The video demonstrates the procedure on the ST-1201.
Step-by-step guide
1. Confirm the alarm and the affected needle
Watch at 00:11Use this procedure when the machine has stopped with a Broken Line alert and the upper thread is still intact. Read the Head and Needle fields in the alert, then check the thread for that needle while the machine is stopped. The ST-1201 in the video shows Head 1 and Needle 3. Use the numbers on your own screen.

2. Trace the upper thread through its guides
Watch at 00:24Follow the affected thread from the needle area up the front of the head. Check that it runs through each guide opening in its own path. The pointer starts below the head at the needle bank and moves up to the vertical threads and guides.


3. Check the one-and-a-half-turn wrap
Watch at 00:33Follow the pointer to the larger black wheel in the lower row on the front of the ST-1201 threading panel. Follow the demonstrated path and wrap the thread one and a half turns around the wheel for the affected thread path. Continue with the sensor wheel above it.

4. Reseat the thread on the break sensor wheel
Watch at 00:42Look above the large wheels for the row of small dotted sensor wheels. On the affected path, check that the thread sits around the rim of its sensor wheel. The close-up shows a misplaced thread. Guide the strand back onto the wheel and check that it follows the rim before you move on.



5. Check where the thread sits in the top tension knob
Watch at 00:56Find the affected thread at the top row of black tension knobs directly below the clear guide tubes. Seat the strand between the tension discs behind its knob. Then check the feed by hand in the next step.

6. Pull gently, clear any snag and test again
Watch at 01:09Hold the thread end near the needles and pull gently. It should feed smoothly without catching. If it feels tight or stalls, follow the same thread up through the front guides, tension area and clear guide tube to look for a snag. The video shows the upper end of the tube being lifted at the rack to free a trapped strand. Gently pull again at the needle area to confirm that it feeds freely.



7. Open the lower cover and check whether the bobbin is empty
Watch at 01:46With the machine still stopped, open the hinged cover below the hoop and pull out the bobbin case by its center latch. If the bobbin has run out of thread, replace it with a wound bobbin. If it still has thread but the machine failed to pick it up, reload it as shown in the next step.



8. Reload the bobbin case and leave a thread tail
Watch at 02:02Place the wound bobbin into the case and draw the thread through the side slot, following the path under the tension spring shown in the close-up. Pull out some extra thread so a tail extends past the case for pickup. Push the case back into the compartment and close the cover.




9. Back up to the last stitched area
Watch at 02:26On the ST-1201 screen, tap the upper-right button in the six-button block to the left of the directional pad. Choose a short increment in the stitch-move controls. The display changes from 100 to 5 in the demonstration. Tap the minus button at the lower left to back up to the last area that stitched correctly. Then tap the return icon at the lower right to close the controls.



10. Restart and check the first stitches
Watch at 02:34With the bobbin cover closed and hands clear, press the left, blue-ringed Start button below the touchscreen. Watch the first stitches where the design resumes. The video shows the needle stitching again. Check that the thread feeds, stitches form at the restart point and the alarm does not immediately return.

