SEWTECHSupport Center 简体中文

Embroider a Shoe with the ST-1501 Shoe Clamp

Applies to ST-1501

Watch on YouTube ↗

Overview

Prepare the shoe, set up the clamp and trace the design before stitching to check clearance around the metal arms.

Step-by-step guide

1. Mark the shoe and apply stabilizer

Watch at 00:24

Mark the center of the embroidery area. Smooth the stabilizer inside the shoe so it supports the entire stitching area.

Mark the shoe and apply stabilizer
Mark the shoe and apply stabilizer

2. Mount the clamp on the machine

Watch at 01:41

Adjust the clamp arms for the shoe. Mount the clamp between the indicated plates and tighten its screws after lining up the holes.

Mount the clamp on the machine
Mount the clamp on the machine

3. Clamp the shoe flat with clearance

Watch at 03:12

Position the shoe with the embroidery area facing up. Check the shoe clears the bobbin area and sits firmly in the clamp.

Clamp the shoe flat with clearance
Clamp the shoe flat with clearance

4. Trace and check before pressing Start

Watch at 03:56

Use the positioning arrows, trace the design and verify the needle path clears the clamp. Confirm the setup and run the design.

Trace and check before pressing Start
Trace and check before pressing Start