SEWTECHSupport Center 简体中文

Routine Maintenance for the ST-1501

Applies to ST-1501

Watch on YouTube ↗

Overview

Use the appropriate oil or grease at each point and clear loose thread buildup during routine service.

Step-by-step guide

1. Prepare and oil the shown points

Watch at 01:23

With power off, clean the hook and apply sewing machine oil. The video then identifies the needle bar, additional oiling point and internal rods.

Prepare and oil the shown points
Prepare and oil the shown points

2. Grease the rails and cam surfaces

Watch at 04:09

Brush a thin coat of grease on the shown rails, rollers and cam contacts. Repeat for the cap driver groove when servicing that attachment.

Grease the rails and cam surfaces
Grease the rails and cam surfaces

3. Clean thread and lint from working areas

Watch at 07:04

Remove lint under the hook cover and clear the thread guides and grooves. Check the needle condition and replace a worn needle as shown.

Clean thread and lint from working areas
Clean thread and lint from working areas

4. Check the controller after service

Watch at 08:49

Reassemble the serviced parts before powering on. Follow the demonstrated reset if the needle position reads zero, and confirm a valid needle number before sewing.

Check the controller after service
Check the controller after service