Flat Hat Cap Embroidery Hoop for Janome MB4 MB4S MB7 MB7S 100x60mm Multi-Needle Embroidery Machine
No se pudo cargar la disponibilidad para recoger
Description
Click Following Link to See How to Use the Cap Hoop
https://www.youtube.com/watch?v=NLzGJa5L7IU&t=2s
>>>> How to use the hat hoop
1. Attach the hoop to the MB-7 / MB-4 hoop brackets. Select the desired design. Using the Edit screen, rotate the design 90 degrees clockwise, so that the top of the design is to the right and the bottom of the design is to the left.
Note:
Only use designs that are designed for the M2 Hoop (4.9in X 4.3 in ). Selecting a design that
is too large for the MB-7 / MB-4 Hat Hoop opening will cause the embroidery feet to hit the hoop and could cause damage to your MB-7 / MB-4 embroidery machine.
2. Use the Tracing function and the placement arrows to verify that the design will stitch within the open area of the hoop.
3. After verifying that the entire embroidery design will stitch within the open area of the hat hoop, disconnect the hoop from the machine.
4. Cut a 8.5” x 12” piece of adhesive stabilizer. Remove the paper backing. Carefully attach the sticky side of the stabilizer to the back
of the hoop, beginning at one side. Gently pull the stabilizer across the opening and press the edges of the stabilizer fi rmly to the
edges of the hoop. If the stabilizer is not pulled fl at and taut, pull the edges and reset the stabilizer.
5. In order to reduce cost and time for several hats at a time, cut out a square (approximately 2.7” X 2.7”) from the embroidery area of the
stabilizer.
6. Using either 1” x 4” strips of adhesive stabilizer or adhesive tape, place 4 strips around the square, sticky side up, to rein force the
square opening.
The Flat Cap Hoop Insert Can be Used for the Following Machines
•Janome MB4/MB-4S/MB7/MB7S
•Elna Expressive 940/ 970
Details of the Flat Cap Hoop
