Set Up and Use the SEWTECH Bobbin Winder
Overview
Fit the thread guide, route the thread through the tension disc and wind an empty bobbin.
Step-by-step guide
1. Fit and tighten the thread guide stand
Watch at 00:28Loosen the locking nut, screw in the stand and orient it as shown before tightening the nut with the wrench.

2. Route the thread and prepare the bobbin
Watch at 00:59Pass the thread through the upper guide and tension disc. Place an empty bobbin on the spindle and wrap the end counterclockwise as demonstrated.

3. Wind and remove the full bobbin
Watch at 01:54Start winding with the red button and check the line accumulates evenly. After the winder stops at full, remove the bobbin and cut the thread.
